I have a Series 2. when starting the motor I turn the key and wait for the beep noise then I crank the motor. Sometimes it beeps again once the motor is started. Is this a warning or something I should be worried about?
I have a Series 2. when starting the motor I turn the key and wait for the beep noise then I crank the motor. Sometimes it beeps again once the motor is started. Is this a warning or something I should be worried about?
I'm not familiar with a "beep" pre or post ignition. I just turn mine over and it fires. No beep involved. I did not realize the Series2 does that.
08 Ranger Reata 210
Yamaha VMAX 225 HPDI
I turn my key for a few seconds to allow the vst to pressurize and then crank it... i don't hear a beep before or after... pull the kill switch and try to crank and it'll beep though.
Current: 2006 ~ 20i ~ 250 HPDI ~ T1-25p
Previous: 2005 ~ ZX 225 ~ 250 HPDI Phase III - TXP 26p
In every Yamaha I've been with, including my own, they don't beep....
Could it just be the guages on my boat? It is a 294 Evo with Actia digital guages.
.
Neil Eckberg- Cary, NC - 2008 Skeeter ZX250- 250 Yamaha SHO
Kerr Lake Ba$$hole
<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by livetofish »</td></tr><tr><td class="quote">Could it just be the guages on my boat? It is a 294 Evo with Actia digital guages.</td></tr></table>
I have Actia gauges and no beep
"Only Member of the EvoZilla Fishing Team"
(Applications being considered)
------Co-founder of Post Derailment, LLC---------
225 S II, mine beeps.I wait until the beep before starting but do not know if that is necessary.
Only dual engine installations do a self test beep at key on--single engine does not. If it's 05 or newer, I beleive water in fuel will beep at start-up in neutral...
Reply With Quote