Cotter pin for prop nut

[wamma]

I know this might be a stupid question but what is the correct size pin for the prop nut on my 200VMAX ? thanks Mike

[Reata210]

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by wamma &raquo;</TD></TR><TR><TD CLASS="quote">I know this might be a stupid question but what is the correct size pin for the prop nut on my 200VMAX ? thanks Mike</TD></TR></TABLE>

One that fit snug in the hole….LOL. Make sure it is stainless as well. If you have a dealer close grab one from them. If not, take the old one to the hardware store and match it up.

[wamma]

Took the prop off over the winter and cant find the cotter pin(my bad).Picked up a pack at west marine but for some reason Im afraid if it isnt thick enough it will break from torque or something. I am probably being crazy but I guess its better too be safe than sorry. Mike

[Reata210]

The pin is there purely as a fail safe and will not experience any torque. If the nut is torqued properly the pin is only there in case the nut backs off. The pin should fit snug and not wiggle in the hole.

[mlee]

Use a 5/32 x 1 1/2" Stainless Steel cotter pin.

[wamma]

thanks everyone