Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Nov 2004
    Location
    Albemarle, NC
    Posts
    151

    1985 GT 150 Cutting Out

    The boat has been sitting now for about 3 months, getting the carpet done and stuff like that, the other day I took it out just to ride around, the motor started fine, and idled fine, but wen I took off I found that it would cut out about every 3-5 seconds for a half second or so, and recover. O looked back a teh clear filter and saw that it was only half full. I then switched the tanks over to the other side, pumped up the bulb, and even though it would cut out, it didn't do it as often. The boat had been sitting with almost no gas in the tanks.

    Could this be water in the system?, bad lines, or just the fact that it has been sitting so long?

    Or worse yet, something bigger.
    A bad day fishing is better than any day of work.....


  2. Member
    Join Date
    Jun 2004
    Location
    Neenah
    Posts
    3,619
    #2

    Re: 1985 GT 150 Cutting Out (flametamer123)

    I assume you mixed the old gas with fresh gas? If not, I would add fresh gas and try it. I would also drop in a fresh set of plugs and try it.



    Modified \'92 Procraft 170 Combo/\'97 Johnson 130<U></U>

  3. Member
    Join Date
    Nov 2004
    Location
    Albemarle, NC
    Posts
    151
    #3

    Re: 1985 GT 150 Cutting Out (ProcraftMike)

    Yes I filled the tanks with new gas, and plugs were next.....I think though I found the problem. When I squeeze the bulb, it sounds like it's letting air in.....so I think I may have a leaky connection. Gonna tighten, and try again tomorrow.

    A bad day fishing is better than any day of work.....


Similar Threads

  1. cutting a rod
    By stratosjoe in forum Rod Building & Tackle Making
    Replies: 5
    Last Post: 02-02-2010, 06:59 PM
  2. '06 225 E-Tec cutting out @ top rpm
    By Bass_Junky in forum Evinrude/Johnson Motors
    Replies: 15
    Last Post: 11-07-2009, 03:42 PM
  3. 1985 120 hp evinrude cutting out at wide open throttle
    By napaman1 in forum Evinrude/Johnson Motors
    Replies: 8
    Last Post: 09-15-2009, 01:43 PM
  4. E-tec 75 cutting out
    By gator123 in forum Evinrude/Johnson Motors
    Replies: 7
    Last Post: 09-04-2009, 05:55 AM
  5. XP 150 Cutting Out ???
    By jaqfan in forum Evinrude/Johnson Motors
    Replies: 6
    Last Post: 01-01-2007, 07:48 AM