Results 1 to 5 of 5
  1. #1
    04 ZX225
    Join Date
    Mar 2007
    Location
    Merritt Island, FLorida
    Posts
    711

    Boat stalls when putting it into gear

    In the past 6 months when I put the boat into gear, whether forward or reverse, about 20% of the time it will stall and I need to restart. I changed the plugs last week and it is still doing it so I am thinking it may be idling low. The boat will idle fine when in neutral or in gear but I am not sure of the RPMs as the gauge is not that granular. I am trying to avoid trailering it a far distance for service.

    Thoughts?

    Thanks,

  2. NC Bass Club/Yamaha Motors Moderator BuzzB8's Avatar
    Join Date
    Jun 2004
    Location
    Asheboro, NC
    Posts
    7,091
    #2

    Re: Boat stalls when putting it into gear (frogbite)

    So, what are you asking? You should be able to find the idle RPM's in your manual, and if you don't have one you can use the link posted at the top to download one. Without a tach, you're pretty much just guessing.

  3. Member
    Join Date
    Nov 2005
    Location
    Prairieville, Louisiana / Zolfo Springs, Florida
    Posts
    5,696
    #3

    Re: Boat stalls when putting it into gear (frogbite)

    It would also be good to know what motor you are talking about.







  4. 04 ZX225
    Join Date
    Mar 2007
    Location
    Merritt Island, FLorida
    Posts
    711
    #4

    Re: Boat stalls when putting it into gear (spider1)

    Whoops, keep forgetting that most would not know what the ZX225 came with. It is a 2004 225 HPDI. Manufactured in 2003.

  5. Member
    Join Date
    Nov 2005
    Location
    Prairieville, Louisiana / Zolfo Springs, Florida
    Posts
    5,696
    #5

    Re: Boat stalls when putting it into gear (frogbite)

    The motor should idle about 700 and about 550 in gear. I think but not 100% the motor may have an o2 sensor. Not sure just when they stopped that on the HPDI's I think 2003?
    You may what to start changing your filters. Start with the one you should have in the boat and work your way out. It should be 4 before the High pressure pump. If that does not take care of the problem then you need to have the low pressure fuel pumps checked.

    There are a lot of us that has not idea on what motor is on what boat.







Similar Threads

  1. 2003 225HP HPDI stalls when put in gear
    By frogbite in forum Yamaha Motors
    Replies: 2
    Last Post: 06-12-2011, 07:01 AM
  2. stalls went put in gear
    By lowe180 in forum Evinrude/Johnson Motors
    Replies: 1
    Last Post: 08-09-2010, 03:47 PM
  3. Evinrude 115 stalls in gear.
    By ameleo in forum Evinrude/Johnson Motors
    Replies: 13
    Last Post: 09-20-2009, 05:39 AM
  4. excessive noise when putting boat in gear
    By avid fisherman in forum Yamaha Motors
    Replies: 3
    Last Post: 06-19-2008, 10:31 AM
  5. Engine kept dying when putting into gear
    By sc419795 in forum Evinrude/Johnson Motors
    Replies: 2
    Last Post: 07-23-2007, 04:54 PM