3.1L swap/electrical wiring question from an electrical moron.

[atomicbass2]

There is a four pin plug off the main motor harness, It has 1 yellow/1 yellow-red stripe/1 black-red stripe/1 green-red stripe. Is this the trim harness? If so,which
wires does the two wire trim sending unit plug( 1 pink,1 black) tie into.I am switching from OMC and have everything needed except this harness. Anyone have any ideas? I know "buy the harness" but I can use my abandoned omc harness if I can figure out these points of connections.If it is the trim harness does it go directly up to my Yamaha brand trim gauge?Thanks

[atomicbass2]

I found out the harness I was asking about is for the yamaha digital gauges.I'm using analog so I don't need it.I hope this can provide someone else some help.

Modified by atomicbass2 at 9:26 PM 4/1/2006


Modified by atomicbass2 at 4:42 AM 4/3/2006

[atomicbass2]

Thanks Buzz! Just here for help from all of you with Yammy knowledge.

[BuzzB8]

Bump