Power Trim Problem

[bayerle]

Motor is a 03 175 Evinrude. The power trim stopped working up and down. I am following the manual to solve the problem. When checking the power supply the instruction is to check for voltage between the B+ from solenoid to terminals 85 and 87a (grounds) of the relays. Should the power cable be unplugged for this check? When I probe the disconnected cable at B+ I don't get any voltage between there and the relay terminals. If I have the connector installed and pick up the voltage from the fuse terminal, I get about 9V on the terminals. Any help will be appreciated. Thanks

Pete

[ELGIN]

Model number would help us help you, Welcome to the BBC.

[Sportwin]

Remove the T&T connector from the power distribution panel (unplug connector with blue & green wires). Apply 12V directly to the 2 wires and see if the t&t motor works. If it does then reply back for further troubleshooting help. If it doesn't then you need a t&t motor.

[bayerle]

Sorry for not reading the rules. The motor model is E175FPLSTB, the serial number is 04999670. I put 12V directly to the motor and it runs. I also have checked the fuse and swapped out both relays. Thanks for any help

[ELGIN]

Sounds like the Power Distribution Panel (PDP) needs to be replaced.

[bayerle]

I have ordered the PDP. Thanks for your help

Pete