SSR Hub Kit for 1" (Standard Shaft) Engines

[EuropeanAM]

New SSR Hub Kit for 1" Propshaft Engine Models. Well suited to the smaller Fourstrokes, can be run on anything up to 300hp with a 1" Propshaft.

Just like the Racing SSR Hub Kit, it provides reduced clutch rattle and smoother shift/operation while still providing a durable hub.

-1" Shaft PLASTIC SSR Hub Kit (normally used on 150hp or below): 8M0150151 (Mercury) 8M0150152 (Quicksilver)- 100 lbs/ft Torque

-1" Shaft SSR "Solid" Kit is: 8M0101602 (Mercury) or 8M0101604 (Quicksilver)- 55 lbs/ft Torque

-1.25" Propshaft Models, use 8M0101601 (Mercury) or 8M0101603 (Quicksilver)- 55.3 lbs/ft Torque



If you're running an SSR Hub Kit, be sure to torque it ONCE for EVERY BLADE on the prop.


With the SSR Hub Kits:

-Insert the hub by hand or with a press (do not attempt to drive it in by hitting it, OR pull it in with the propnut).

-Split the required torque up between the blades (3 times for a 3-blade, 4 times for a 4-blade).

Example: 3 Blade Prop:

1. Install hub kit into prop bore by hand. Some 2-4-C or Dish-Soap will aid in installation

2. Install Prop and Hub onto the shaft.

3. Install washer(s) and nut, pull nut down with 1-1/16" socket until just snug.

4. Place first blade against a block/board (wedged between anti-ventilation plate and blade).

5. Torque nut to 20 lbs/ft.

6. Place second blade against a block/board (wedged as in #4), Torque nut to 40 lbs/ft.

7. Place third blade against a block/board (wedged as in #5), Torque nut to 55 lbs/ft.

(4 Blade props are similar, split torque into 4 settings).