Over the winter I did a little updating to my 201pxl.....
ALso need help with setup...
03 201pxl
08 225ho
8.5 inch setback
2.75 below pad
26 rakerII
Full tank of gas and all gear
Was running 70 at 5700 rpms
is that about right? should I try another prop?
Where did you find those fenders? Did the fender board match exactly? I'm looking for a set and I found some from C&O. My fenders are 65"L x 12"H x 9W" tapers.
Make sure you maintain water pressure as you raise,to me 70 is a respectable number with dual power poles and loaded
Airing a boat does not always add speed some boats run faster not as high a trim,its more for looks and photo shoots,rear rooster tail should be but motor high
Last edited by lilmule; 10-05-2014 at 05:31 PM.
Guys this post is over four years old, and looking at users profile he has not posted here since 2011. The fenders on that trailer are probably installed at the factory being that they were an option back then. Stratos will sell you stainless fenders for your trailer, but you'll dig deep into your wallet to pay for them.
Reply With Quote