Could someone please tell me which bracket i need for my power pole. I have a ZX200 and I think I want the one that mounts on the side of my slidmaster. . just not sure on riser height and offset. What bracket do you have on your skeeter?
Modified by ericj at 10:40 AM 2/23/2011
call power pole and tell them your make and model and they will help you. that is what i did. I put mine on the starboard side and it works great never had a problem, but you will have to take the piece that says slidemaster off so that it mounts flush to the jack plate.
I just ordered one for my boat a ZX225 you'll need one with a 7" setback and 3" rise. The part number would be pk-s-7-3-s-blk (last s would be a p if you want a port side version).
Send Hydrilla Gear a PM he'll get you setup he's a board sponsor and power pole dealer. You'll be looked at about $159 for one but you'll also need a bolt set as your existing bolts will be too short.
Current: 2006 ~ 20i ~ 250 HPDI ~ T1-25p
Previous: 2005 ~ ZX 225 ~ 250 HPDI Phase III - TXP 26p
I have a new pk-s-7-3-s-blk bracket I'll sell you for $125 if you are interested.
BPSKEETER, I wish I had known that yesterday.just spent $160
How much clearance from the sponson r u guys getting with the 7inch aft 3inch rise? I'm still shopping around for the perfect bracket. Likely ftp with the 9inch aft 3inch rise.
Not sure on the exact clearance ,but I can tell you the pk-s-7-3-s-blk worked perfect for me. And I'm kinda picky.. Hope this helps..
Not looking for exact meas. Just an est, like 1", 2", 3", etc............ from the sponsons.
04 ZX250/300 VMAX HPDI
It's about 3" using the plate i mentioned above. I face the bolts away from the baot too.
Current: 2006 ~ 20i ~ 250 HPDI ~ T1-25p
Previous: 2005 ~ ZX 225 ~ 250 HPDI Phase III - TXP 26p
Does anyone have a top view pic. Visual is always good. I'm interested in where about its position vs the sponsons.
04 ZX250/300 VMAX HPDI
Reply With Quote