Hey guys,

I know there have been other inquiries re: this subject, but I hae yet to find an answer to my specific issue.

I have a 95 Skeeter 190ZX that is set up for a 24V system. I have 3 6guage (2 Hot, 1 Grnd) going to the front (into what looks like a block, that the trolling motor is set up with) trolling motor from the back. The back is set up like this, onboard charger (2 bank) into the back panel (with 30Amp circuits X2) then to the batteries and then to the front.

This may sound confusing, sorry for that.

What is the best way to convert this to a 36V system? I know I could run the batteries in series and only use one of the hot wires that go up to the front, but I'm worried that because there are 2 Hot wires going up there now that if I changed it and only used 1 6 guage wire that it would over heat.

Should I do as I mentioned and only run one set of wires after putting the batteries in series?

Should I run another Hot wire up front and try and find a block that will go from 3 Hot wires to 1 out to the trolling motor?

Suggestions?

Thanks,