How did you run the hydraulic lines into the bilge from the power pole?? I hate to drill holes in the hull if I don't have to.
I am considering running them thru the black plastic piece at the rear where the rub rail meets between the jack plate???
Thanks, John.
I ran mine thru the big black plastic tube that all of your wiring runs thru. I took a razor knive and cut a small square right at the engine cowling by where the split is on the tubing. I ran both tubings thru there into the bilge. I then put two black tie straps around the big tube, one in front of where the lines go in and one behind where the lines go in. Works great.
Reply With Quote