Where can I get the ones like came in my zx 200. They are the red button 40 amp. I have installed a new 82 lb motorguide an on high it will kick out the breaker.
Where can I get the ones like came in my zx 200. They are the red button 40 amp. I have installed a new 82 lb motorguide an on high it will kick out the breaker.
Cabelas used to sell those.. Why not buy the brand "short stop"? I think Gander Mountain sells those and they attach right to the batt terminal.
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
Phone Debbie at BH Electronics on 901-837-1111. This is where I got my 50 amp ones to replace the 40 amp breakers. They are not set up to take credit cards, so you will have to have them ship COD. BH Electronics are the OEM of the circuitry panel which contain the breakers. I believe the breakers themselves are made by Texas Instruments.
FWIW, I went through the same issue after replacing my 67 lb MG with an 82 lb. My Skeeter is a 1994 200zx and has the breakers mounted on a run / charge panel in the rear compartment. The circuitry is quite complex and I think contributed to the breaker tripping issue as it has several very short lengths of 10 guage wire in the run / charge circuit. Since I have a built in charger, I disconnected all this part of the circuitry so that the TM circuit goes from the batteries straight to the breakers, then straight to the TM plug at the bow.
Sorry for the long response, but thought you might find it helpful if your Skeeter has the run / charge panel.
Reply With Quote
.jpg)