2007 Champion 200 elite

[Jbass2]

I have got the touch pad controls. Yesterday when I hit the livewell fill button nothing happened. The light just started blinking. I turned the power button off to see if it would reset. When I turned it back on the livewell fill button was still blinking. Does anyone know what the problem might be and how I can fix it?
Thanks for the help.

[Lea]

Possible debris in the intake? Or try the reset behind the switch or on the sidewall Starboard? Someone will be along who can help.....

[FlippinUpwin]

Disconnect the power to the black box in the Battery compartment.That controls all the touch pads.If it still does it you have a bad box and Champion coes know about this problem. Good Luck

[Lea]

Thanks, Chris!!!!!!

[Jbass2]

I assume I should just unscrew the two bolts and pull those two wires off. You are not talking about unplugging all o the plugs are you. thanks for the help

[The Other Big Ed]

My #1 airater pump just did the same thing this weekend.

I hit the switch to start the #1 airater and both the manual/auto lights are now blinking red. Pump #2 runs just fine on auto or constant. I turn off the perko switch a couple of times and it still blinks red.

2007 Champion 200 Elite.

Thanks; Big Ed!

[dvbass]

Unscrewing the two nuts will disconnect the power and let the megalink box reset as FlippinUpwin stated. Also, you may have a small LED light on the megalink box. If that LED is blinking, it means something is not communicating properly.

[The Other Big Ed]

Well my blinking lights reset by depressing the switch on the key pad down for 10 seconds continously. Upon trying to start the pump both light would come back on and flash red.

I called Anglers marine this morning and they had me drop it off for a warranty repair. Ive had my boat now for 10 months so its still covered by the warranty.

Later; Big Ed!

[Lea]

Good deal! Good folks at Anglers....