Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    May 2006
    Location
    Boynton Beach
    Posts
    4

    E-TEC Engine Trim Indicator not working

    Anyone else not able to get engine trim info over I-Command? Engine trim (given to you either in % or angle) is available on my I-Command gauges, but the information the motor EMM gives back is incorrect. It reads 0 no matter where the engine is trimmed to.


  2. Member
    Join Date
    Apr 2006
    Location
    willard
    Posts
    126
    #2

    Re: E-TEC Engine Trim Indicator not working (MacAttack)

    first the dealer need to set the trim low and trim high settings with the key on using the evinrude diagnostic software.
    also you got to be sure theI-Command igniton trim harness was used. The trim circuit is wired differently and the signal has to pass thru the I-command harness and back into the EMM.

  3. Moderator SEAHORSE's Avatar
    Join Date
    Jun 2004
    Posts
    9,638
    #3

    Re: E-TEC Engine Trim Indicator not working (MacAttack)

    It depends on what particular motor you have. some may need a software update to help with the I-Command. see your dealer.
    -----


    A Technical troubleshooter possessing more tools than talent !

Similar Threads

  1. 2010 200 Pro XS Issue: One Beep and Engine Indicator Showing on Smartcraft
    By jdbassman in forum Mercury - 3 Liter & 3 Liter High Performance
    Replies: 5
    Last Post: 03-28-2011, 01:25 AM
  2. TRIM INDICATOR
    By CStewart in forum Yamaha Motors
    Replies: 11
    Last Post: 07-28-2010, 09:17 PM
  3. Trim Indicator Help
    By Alabama Chris in forum Yamaha Motors
    Replies: 19
    Last Post: 10-12-2009, 05:34 AM
  4. Trim indicator not working
    By dfaulhaber2k1 in forum Evinrude/Johnson Motors
    Replies: 2
    Last Post: 05-06-2007, 06:55 PM