Results 1 to 5 of 5
  1. #1
    Member
    Join Date
    Jan 2006
    Location
    Ottawa, Ontario, Canada
    Posts
    1,350

    HPDI Fuel problem casues stalling

    I've an 05 225 HPDI. It seems to burn the gas inside the motor then stalls. If you re-prime then it runs for a bit longer then stalls again. It worked fine yesterday but today's tournament was a bust

    I've replaced the primer bulb AND the 2 diaphrams but it still won't run correctly.

    Any ideas?

    It sounds like it's staved for gas but what else should be checked?

    Current: 2006 ~ 20i ~ 250 HPDI ~ T1-25p
    Previous: 2005 ~ ZX 225 ~ 250 HPDI Phase III - TXP 26p

  2. Member
    Join Date
    Nov 2005
    Location
    Prairieville, Louisiana / Zolfo Springs, Florida
    Posts
    5,696
    #2

    Re: HPDI Fuel problem casues stalling (SkeeterJohn)

    Could be your fuel line.







  3. Member
    Join Date
    Jan 2006
    Location
    Ottawa, Ontario, Canada
    Posts
    1,350
    #3

    Re: HPDI Fuel problem casues stalling (spider1)

    I followed it and there's no kinks or signs of any problems. I also changed out the racor filter tonight but i highly doubt it was caughing an issue.

    Current: 2006 ~ 20i ~ 250 HPDI ~ T1-25p
    Previous: 2005 ~ ZX 225 ~ 250 HPDI Phase III - TXP 26p

  4. Member
    Join Date
    Jan 2006
    Location
    Ottawa, Ontario, Canada
    Posts
    1,350
    #4

    Re: HPDI Fuel problem casues stalling (SkeeterJohn)

    When the ignition key is turned the fuel pump inside the vst doesn't run. However when i power it directly with cables it runs. I've already checked the fuse for the pump and it's fine.

    Any ideas?

    Current: 2006 ~ 20i ~ 250 HPDI ~ T1-25p
    Previous: 2005 ~ ZX 225 ~ 250 HPDI Phase III - TXP 26p

  5. Member
    Join Date
    Jan 2006
    Location
    Ottawa, Ontario, Canada
    Posts
    1,350
    #5

    Re: HPDI Fuel problem casues stalling (SkeeterJohn)

    I had it looked at today and it seemed that the fuel pump relay was bad. The ECM and fuel pump itself seem fine. I've ordered a replacement part which should be in for thursday... that's cutting it fine for a big tournament i have this weekend but once i get it i'll reinstall it and we should be good to go.

    Current: 2006 ~ 20i ~ 250 HPDI ~ T1-25p
    Previous: 2005 ~ ZX 225 ~ 250 HPDI Phase III - TXP 26p

Similar Threads

  1. 2005 HPDI 250 stalling
    By Tim65 in forum Yamaha Motors
    Replies: 3
    Last Post: 06-02-2009, 03:31 AM
  2. HPDI fuel system problem?
    By Bass Counselor in forum Yamaha Motors
    Replies: 2
    Last Post: 06-02-2008, 07:39 PM
  3. Replies: 0
    Last Post: 05-29-2008, 07:10 PM
  4. 03 225 HPDI, stalling
    By HAWKFAN in forum Yamaha Motors
    Replies: 1
    Last Post: 07-11-2007, 01:56 AM