Which one seems to work the best for a Minn Kota??? Any info will help, good or bad.
Which one seems to work the best for a Minn Kota??? Any info will help, good or bad.
20XRD
I bought the MK one years ago, But my dealer drilled MG holes and the MK disconnect one is not wide enough. The MK TM has both hole patterns.
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
Hey, less flack outta you.
I'm gonna try for 3 digits this winter.......just preping now.
20XRD
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by FL Dell »</TD></TR><TR><TD CLASS="quote">Hey, less flack outta you.
I'm gonna try for 3 digits this winter.......just preping now.
Sounds good!!! I'll even help ya!!
I'll be your pace boat and give ya something to try and catch up to
I really like the mount Mke Rey sells. I used it with my Minn Kota works great and looks good also
why not pick up a CUSTOM Hydrilla Mount? Its been lightend and Race tested
wow hydrilla that looks good!
Rich you need to update your website. I don't see those, How much?
Rich, Thats about the BEST lookin Detachable bracket I've ever seen!!!!
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by TarheelXRD »</TD></TR><TR><TD CLASS="quote">Looks very good how dose it mount</TD></TR></TABLE>
The opposit side of that slid plate mounts to the bottom of the troller base. You then slide the troller into the plate on the boat fron the front. The 2 plates lock together with 2 allen set screws. It don't move
This side attatches to bottom side of troller
This is what it would look slike slid together
I originally started off with the idea of selling these plates. At this time I have not been able to find any extruded railing that will work the same. Because of the fact that this plate started off as a factory Minn-kota mount, that alone eats up a 110.00 bucks right out of the gate. By the time it is said and done I bet I have 275.00 just in parts and labor. Machine work, anadize set-screw etc. I am working on it though.
The 1st plate I did I had to trash. I ran into some unforseen problems. I does work great though and I pulled 5+lbs off the factory minn-kota mount.
If anyone can help me find a source for a slide plate I will make them one for free. I would like to be able to sell these to the Bullet community. At this time the money is just not justifiable. Unless you are all about the custom
Reply With Quote
.jpg)
