Were did you get that pic Lou?
"The bitterness of poor quality & service remains long after the sweetness of low price is forgotten"
Borrowed it from you Bud
Just trying to help all
I agree!
just had to gig ya a little!!!
I haven't been on the boards for a while - I see a different boat - I thought you had your eye on a new 21XRD - Do you like the new ride? - Fred
Fred, had my eye on several boats but went with the Stroker for several reasons!! I like her more each time I take her out.. ANd that has only been twice so far.
Hey Lou!! Long time no speak lol. Can you give me some details about how the 20xd was loaded when these tests were conducted??? Thanks, Shayne
Actually that test was on a 20XDC, not an XD. The test was done with two people, three batteries, a motor guide troller, the livewells empty, and a full tank of gas(about 30 gallons). The boat had a 12 inch Rapid Jack., 1.62 Sportmaster lower unit, and was run around 1 1/2 to 1 3/4 inches above the pad. That is the information that I have read about the test, some of it may be off a little, you know how the net can be.
Thanks Spec!! What prop are you running for fishing?? Dont you have the same setup? Thanks alot.... Shayne
My set-up is quite different. I have a 10 inch Detweiler Hydraulic plate and a Minn Kota Pro 80 Troller (Very Heavy). I run a 28 Bravo 1 with one inch vent holes to fish with. It will consistently run 88-90 loaded to fish with two people and has a great hole shot. I have ran a 30 Bravo 1 that had one and a quarter inch vent holes and the holeshot was almost the same but it ran about 3 miles an hour faster. I just haven't tried to find me one to buy as I have been very happy with the 28 Bravo so far.
2001-21XDC-300r
Pete.
Hey Louis I realize this is an old thread but I just repowered to a 250xs on my 20DC and am interested. Where can I view this test I see its gone from the first post now
Thanks
Charlie B
Charlie B
Ranger Z521C w / 250 Yamaha SHO
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Bullet20dc »</TD></TR><TR><TD CLASS="quote">Hey Louis I realize this is an old thread but I just repowered to a 250xs on my 20DC and am interested. Where can I view this test I see its gone from the first post now
Thanks
Charlie B</TD></TR></TABLE> Here you go Charlie!!!
http://www.bwbmag.com/output.cfm?ID=1221571
Charlie B
Ranger Z521C w / 250 Yamaha SHO
Thankd Darryl, I was outa town since Friday morning.. I do need to put this back up
I just bought a new 21xrd w/ performance prop - there aren't any markings, mfg, or pitch - how can I tell if it IS a performance prop and size?
Take the nut and washer off and look there on the top of the prop hub, it will say performer and pitch..
Lou,
Top of hub - EOT-14327-RU and (10) on separate stamp - no other markings - I'm puzzled???
Reply With Quote
