1988 (i think) 30 hp Evinrude long shaft will not start. i've replaced the ignition switch, had the starter rebuilt (new brushes), replaced the solenoid, and the battery is good. I'm getting good voltage everywhere but when i turn the key, the bendix spins but doesnt kick up against the flywheel. It's sort of acting like its grounded out somewhere and the solenoid wont click. I noticed a melted wire on the rectifier on the other side of the motor but i've replaced that and still nothing. I was able to jump from the battery straight to the starter hot post and it cranked, but i tried it again and it only spins the bendix and wont engage. Could it be the rectifier? I figured that since that only comes into play after the ignition, it shouldnt be the problem. Does anyone have a wiring diagram for this motor or know where i can find one? Anyone have any ideas? I've been out of the water for about 2 weeks and its killing me. Any ideas or help would be GREATLY appreciated! I will post the model # later if it's needed, i'm at work right now and dont have access to it. Thanks yall!