injector removal

[mrd821]

Hi everyone

I have a 01' 225 fitch model # E225fpxsif, serial #G-04929153

I want to know if it is ok to remove injectors to send out for flow ck and cleaning.

it sat for 4 yrs. I'm told. I've preped her up now the
Motor runs @1500rpm with throttle advanced on muffs, @1000rpm it runs but lopes a little, in neutral putts a couple times then stalls. Fuel pressure 30psi while running. comp is 125 on all cyl. today I noticed oil leaking out of the prop (not much) I think injectors maybe clogged and/or leaking ??? Im a rookie asking for help to get this motor running.

thx
mrd

[ChampioNman]

Yes they can be removed and sent out for calibration. http://www.dfitechnologies.com can fix you up. Follow the proceedure in the shop manual and you will be fine. There is a very good shop just up the road from you, Barnacle Bills that can fix you right up. Check them out here http://www.etecownersgroup.com.

[mrd821]

question can I spray CRC throttle body & air intake clearer into either or both the fuel supply and return of the injector assy. to clean it? Or can it be disassembled

mrd


Modified by mrd821 at 3:21 PM 5/27/2010

[Bassmeister]

No, carb spray or something of that order will wash the cylinders of oil.

[mrd821]

I do mean once I remove them from the block.

[Danrude]

If you are going to cleam them that way then use the DeepCreep, the spray form of SeaFoam.