Results 1 to 4 of 4
  1. #1
    Member
    Join Date
    Feb 2009
    Location
    Brownsburg
    Posts
    27

    1973 Johnson 65hp must run with choke

    A buddy of mine just bought and old boat and can only achieve half throttle with the choke at least half on. We have adjusted a little on the idle/air screw but with little success. Im going to clean the carbs tomorrow after work but i could use a starting point for that idle screw. PS the motor will run like a top when not in the water.
    1994 Hydra Sports Z-260
    Suzuki DT 115
    Minn-Kota Power Drive 40 Needs about an 82 Fortrex $$$ its coming
    Eagle Fish Easy 320
    Humminbird 400TX

  2. Sprint Boats Moderator Bassmeister's Avatar
    Join Date
    May 2004
    Location
    Calhoun, Ga.
    Posts
    47,079
    #2

    Re: 1973 Johnson 65hp must run with choke (lawnwarrior)

    No back pressure, IE not in the water, they will idle higher and sound good. In the water they have back pressure and will idle lower. If you're having to half choke it to get it to run right, then you're on the right track, sounds like a carb is running lean. Pull the drain plugs and assure yourself that all carbs are getting fuel, and as you stated, rebuild 'em.

  3. Member
    Join Date
    Feb 2009
    Location
    Brownsburg
    Posts
    27
    #3

    Re: 1973 Johnson 65hp must run with choke (Bassmeister)

    Looks like we got it the two bottom carbs had a blockage in front of the pickup in the bowls. What a mess always run sta-bil before you park it.
    1994 Hydra Sports Z-260
    Suzuki DT 115
    Minn-Kota Power Drive 40 Needs about an 82 Fortrex $$$ its coming
    Eagle Fish Easy 320
    Humminbird 400TX

  4. Sprint Boats Moderator Bassmeister's Avatar
    Join Date
    May 2004
    Location
    Calhoun, Ga.
    Posts
    47,079
    #4

    Re: 1973 Johnson 65hp must run with choke (lawnwarrior)


Similar Threads

  1. 1973 65hp evinrude rods
    By jcb9901 in forum Evinrude/Johnson Motors
    Replies: 0
    Last Post: 07-22-2007, 01:41 PM
  2. 1973 65hp parts interchangeableity
    By jcb9901 in forum Evinrude/Johnson Motors
    Replies: 6
    Last Post: 07-14-2007, 03:18 AM
  3. 1973 Johnson 65hp, water in cylinders
    By strongcones in forum Evinrude/Johnson Motors
    Replies: 4
    Last Post: 04-29-2007, 08:06 AM
  4. 72' 65hp Johnson
    By Sportcrafter72 in forum Evinrude/Johnson Motors
    Replies: 3
    Last Post: 11-20-2006, 05:39 AM
  5. What can you all tel me about a 1973 Johnson 65HP model # 65ESLR73
    By Bman72 in forum Evinrude/Johnson Motors
    Replies: 2
    Last Post: 02-19-2006, 09:48 PM