Just curious does my 05 ETEC 250 DPLSO have a rev limiter on it? I was testing props not to long ago and one of the guys with me was saying we never hit the rev limiter?? I only have stock Ranger RPM gauges and it was reading somwhere between 5800 and 6000 but that only estimating since it is marked in 500rpm increments. Any ideas?
This will be informing......I've always wanted to know. My engine hasn't been over 5850 the tech said last time I was in.
Yes it does but its not like the limiters of old where the engine pops and shakes it will simply not run over the limit.
Elgin, will it shut off or just hold at that level...and do you know what that is set at for an 05 ETEC250 DPLSO?
My 09 250 Ho with its best prop turned 6000-6100. i had called brp and they told me that was fine.
BassCat-illac
FastCat Fishin Team
If you aint first , your last !!!
All fat girls welcomed !!!!!
It will hold at that RPM, depending on what version software you are running it should be around 6050.
Before all the posts start about what the tach reads when you hit the rev limit I would suggest you have your tachs checked AGAIN with the diagnostic software.
Reply With Quote
