5.12 Waypoint Sharing

[Hydro870]

Console Units are Solix G3 and Apex.
Bow Unit is Solix G3

All units have 5.12 Software, and already went through restore factory settings.

Console Solix is direct Ethernet cable to Console Apex. Console Apex is direct Ethernet cable to Ethernet switch. Ethernet switch is direct cable to Bow Solix.

Wapoint sharing worked perfect with all previous software versions.

With 5.12, when I create a waypoint on my Console Apex it only shows up on the Bow Solix. When I create a waypoint on my Console Solix it only shows up on the Bow Solix. However, if I create a waypoint on my Bow Solix, it does not show up on any other graphs.

…..so then I shut all the graphs down and restarted them.

Now when I create a waypoint on the Console Apex, it does not show up on any other graphs. When I create a waypoint on the Console Solix it only shows up on the Console Apex. When I create a waypoint on the bow Solix it only shows up on the Console Apex.

It’s like two graphs will only share new waypoints to one graph, but that one graph won’t share new waypoints back to the other two. Then after restarting, it switched which graph was allowed to be shared by the other two, but then that graph no longer shared back to them. Same problem, different graphs.

Everything else shares, including mapping and settings. Thoughts?