I have an Xpress x19 pro with 200 sho. I've tried a few props and I still would like to dial it in a little better.
It was set up at 3.5" PtP when I bought it. After reading some I have raised it to 2.25" PtP. I'm not getting the speeds I should be getting.
I've tried a few props and they all basically run between 60 and 62 mph. I just noticed that my hotfoot was not adjusted properly (it was overturning the throttle) so I might get a little more speed out of it when I try it again.

The question I have is:
At 3/4 trim on the gauge is where it consistently drives the best. After that, the steering gets tight and it chine walks. At the 3/4 trim mark I am around 5000 rpm. When I trim it all the way (on the gauge) it is closer 6000 rpm but it drives terrible.
Will reducing the PtP help with the driving or do I need to prop it to get 6000 rpm at 3/4 trim (on the gauge)?

Props at 3.5" PtP
24 tempest 62 mph 6200 rpm trimmed all the way
25 Fury 60 mph 5900 rpm trimmed all the way up
25 powertech 62 mph 5700 rpm trimmed all the way up