Results 1 to 6 of 6
  1. #1
    Member
    Join Date
    Jun 2019
    Location
    Greenwood, IN
    Posts
    2

    2007 skeeter 20i livewell pump problem

    I've had issues with my starboard side live well pump for some time now. When the boat is setting without the engine running it works fine. Two seconds after I engage the engine the pump quits and the touch pad starts blinking. I've had both live well pumps replaced recently but this did not solve the issue. Anyone know the problem?

  2. Member
    Join Date
    Jun 2007
    Location
    SE, PA
    Posts
    1,460
    #2
    Might be a DMS problem since you said the pad starts blinking? I'm sure others will chime in with suggestions

  3. Member
    Join Date
    Feb 2017
    Location
    conway AR
    Posts
    729
    #3
    this sounds fairly straight forward since the pumps are new. time to upgrade to a FXR and you wont have this sort of thang!!

  4. Banned
    Join Date
    Jun 2004
    Location
    Kissimmee,Fl
    Posts
    4,479
    #4
    Tried holding LW pump switch in for a few seconds(cant remember 10, 20 or 30) to reset pump circuit?
    Hopefully its not "The Brain Box".

  5. Member
    Join Date
    Jun 2019
    Location
    Greenwood, IN
    Posts
    2
    #5
    Yes, I can hold it in for about 7 seconds and it will reset but once I place the boat in gear the pump shuts off and the lights start blinking again. My boat dealership can't figure it out either.

  6. Member
    Join Date
    Apr 2011
    Location
    Lake Fork
    Posts
    725
    #6
    Are your graphs on? If so turn them off and try again. If pumps work, wire graphs straight to battery. Good luck.
    Wes

Tags for this Thread