Results 1 to 3 of 3
  1. 05-03-2009, 05:28 PM #1
    omcforever
    omcforever is offline
    Ohio Fishing Reports Moderator omcforever's Avatar
    Join Date
    Nov 2007
    Location
    Miamisburg Ohio/Formerly Aiken SC
    Posts
    20,145

    1991 Fast strike 175 help

    Need to know where to install the nipple for my water pressure gauge,,,,thanks,,,Art

    Age and treachery will always overcome youth and skill !!
    Reply With Quote Reply With Quote
  2. ChampioNman
    ChampioNman is offline
    SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    72,138
    #2 05-03-2009, 06:33 PM

    Re: 1991 Fast strike 175 help (omcforever)

    Look between the #2 and #4 cylinder you will see a brass plug close to the center of the motor that is where it goes.
    Reply With Quote Reply With Quote
  3. omcforever
    omcforever is offline
    Ohio Fishing Reports Moderator omcforever's Avatar
    Join Date
    Nov 2007
    Location
    Miamisburg Ohio/Formerly Aiken SC
    Posts
    20,145
    #3 05-03-2009, 07:06 PM

    Re: 1991 Fast strike 175 help (ChampioNman)

    Thanks ChampioNman,,,,Art

    Age and treachery will always overcome youth and skill !!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 1991 Fast Strike 150 lower unit?
    By walker07 in forum Evinrude/Johnson Motors
    Replies: 1
    Last Post: 03-29-2010, 05:12 PM
  2. 1991 Fast strike water valve??????
    By omcforever in forum Evinrude/Johnson Motors
    Replies: 2
    Last Post: 06-23-2009, 05:51 PM
  3. 1991 Fast strike cooling issue
    By omcforever in forum Evinrude/Johnson Motors
    Replies: 3
    Last Post: 05-24-2009, 05:31 AM
  4. 1991 Fast strike 150 question
    By cape cod basser in forum Evinrude/Johnson Motors
    Replies: 2
    Last Post: 10-10-2006, 05:40 PM
  5. whats needed to hook up h2o psi guage to head on 1991 fast strike 60 degree engi
    By Frank A in forum Evinrude/Johnson Motors
    Replies: 3
    Last Post: 08-20-2006, 04:06 PM