40 h.p. evenrude mod.# E40ELCO Ser.# G1009555 can anyone tell me how to drop the lower unit ? It will come down about 1" then it will stop. I put it in rev. dropped a bit more but still will not come off.
40 h.p. evenrude mod.# E40ELCO Ser.# G1009555 can anyone tell me how to drop the lower unit ? It will come down about 1" then it will stop. I put it in rev. dropped a bit more but still will not come off.
Where do you disconnect it at ? I can not find any way at the lower unit. Never did a omc. merc. and yamaha just drop down.
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by nattam »</TD></TR><TR><TD CLASS="quote"> Where do you disconnect it at ? I can not find any way at the lower unit. Never did a omc. merc. and yamaha just drop down.</TD></TR></TABLE>
There is a little screw below the carburetors that you will have to remove in order to get the LU off.
Burning the candle at both ends.
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by 302w »</TD></TR><TR><TD CLASS="quote">
There is a little screw below the carburetors that you will have to remove in order to get the LU off. </TD></TR></TABLE>
So, there are other people in this world who curse that pesky lil ole shift-rod screw besides me.
If you can't run with the big dogs, just stay on the porch.
Model E150DPLIIB, Serial 05311818, Mfg Date 02/2011
SST... 14 1/2" x 19" 45.0 mph.@4950
Rebel 15 1/2" x 17" 45.1 mph.@5250
Rebel 15 1/2" x 16" 44.6 mph.@5300 (Re-pitched/Balanced/Blue Printed by Mark's Props)
Rebel 15 3/4" x 15" 44.2 mph.@5700-5750
Remove the port side belly pan it will make your life easier.
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by DoferGofer »</TD></TR><TR><TD CLASS="quote">
So, there are other people in this world who curse that pesky lil ole shift-rod screw besides me.
</TD></TR></TABLE>
lol, yeah I liked OMC's up until that point.
Burning the candle at both ends.
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by 302w »</TD></TR><TR><TD CLASS="quote">
lol, yeah I liked OMC's up until that point.
Sometimes it's a lot easier just to remove the starter for easy access to the screw.
-----
A Technical troubleshooter possessing more tools than talent !
If I did that I might not have been able to put it back together. I'm great at tearing chit apart, it's the putting it back together that gets me.
Burning the candle at both ends.
Thanks for the help on the lower unit guys. I had to remove the starter to get to the bolt, what a b****!
Reply With Quote
