Install of Rod buckles on a ZX225

[Carlos H]

This post was inspired by Temple!

Installed a set of rod buckles on my buddies ZX225

here is the complete set of pics.















Only caution is the starboard side. If your weapon of choice for making the hole is long, you can cut into the wire loom. I have a small cutter that I use that is very short, so i did not have to worry about that.

[skeeter 190]

Looks really nice.

[Rodney Bledsoe]

Great info Carlos, I have put a short cut to this post in the (Skeeter Accessory & Rigging that is pinned at the top of the page.

[KjunSkeeter]

Not to jack the thread, but here's some pics of how I did mine concealed on my ZX225. I cut a little piece of carpet out to make some room for the cleats, and used them to patch where the original anchors were screwed in. Overall very simple, and quick.

[drjochum73]

This post was inspired by Temple!

Installed a set of rod buckles on my buddies ZX225

here is the complete set of pics.


Thanks that helps alot and it looks great. Appreciate it.

Dan















Only caution is the starboard side. If your weapon of choice for making the hole is long, you can cut into the wire loom. I have a small cutter that I use that is very short, so i did not have to worry about that.

Thanks. I appreciate the information and it looks great.

Dan