jack plate for outlaw

[n10sivern]

i'm thinking about replacing the jackplate on my 98 outlaw 19'. it has a 4-5" JP on there now. any benefit to go to a 10" or what size should i have?

[bigGUNS04]

I just bought a 10" bobs for my '98 Intimidator... Hope to install it soon

[low slung cruiser]

ive got a 12" bob hyrdaulic, and the extra 8" of set back did nothing to add performance...if anything, it slows hole shot....
2003 OUTLAW with 2002 225 Merc EFI

[bigGUNS04]

<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by low slung cruiser &raquo;</td></tr><tr><td class="quote">ive got a 12" bob hyrdaulic, and the extra 8" of set back did nothing to add performance...if anything, it slows hole shot....
2003 OUTLAW with 2002 225 Merc EFI </td></tr></table>

WHOA you have 20" of total setback?! I would assume that would hurt it a LOT

[ldbass55]

go with a 6, or at the most an 8...
LD

[low slung cruiser]

no big guns, i have a 12" bobs hydraulic...
WHERE DO YOU FIGURE 20"?????

[low slung cruiser]

did not say i had 12" plus 8"....
I SAID i had a 12" BOBS hydraulic, and its 8" longer than my previous, and it made "NO" increase in performance...if anything it slowed my hole shot down....

[TheDuke]

I went with a 10 rapid jack, and so far so good

[bigGUNS04]

<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by low slung cruiser &raquo;</td></tr><tr><td class="quote">did not say i had 12" plus 8"....
I SAID i had a 12" BOBS hydraulic, and its 8" longer than my previous, and it made "NO" increase in performance...if anything it slowed my hole shot down....</td></tr></table>

gotcha...mis read it then PHEW I was like holy shyt...