How do I remove my lanyard switch?

[95202DCX]

That's just not how it's done, It's not a big deal to fix it right. It would take me a whole 15min. to make it NEW with the parts on hand.

I have a used one I could send you.

This one is new...http://www.ebay.com/itm/New-Mercury-...-/271546919943

[98 Elite203]

That's just not how it's done, It's not a big deal to fix it right. It would take me a whole 15min. to make it NEW with the parts on hand.

I have a used one I could send you.

This one is new...New Mercury Mercruiser Quicksilver Part 87 13398 2 Switch | eBay

I guess im confused on what your saying to get this thing off.

Does the whole throttle assembly come off as one piece?

[scotty34]

I guess im confused on what your saying to get this thing off.

Does the whole throttle assembly come off as one piece?

Yes
1 Push neutral button in and move handle to 9 o clock position
2 CAREFULLY pry out center neutral button
3 Remove nut in handle ( I think its 5/8 or 11/16"
4 Remove handle caefull with trim wires
5 Pry off decal plate you now will see the 7/16 bolt heads that hold the control box on.
6 Reach behind control box support its weight as u take out the bolts
7 Now you might be able to squeeze the release tabs on the safety switch, if not remove the face plate assy.
Just reverse the steps to re assemble, look closely at the trim wires make sure they arent damaged at the pivot point "bottom of handle" you must reinstall handle at 9 o clock position. Verify F-N-R is ok before finishing.