Results 1 to 7 of 7
  1. #1
    Member
    Join Date
    Apr 2007
    Location
    Warm Springs, VA
    Posts
    1,713

    Evinrude 150 Intruder Problem Part 2

    Fishing yesterday morning, it goes through its usual bout of sputtering then hard miss running wide open. Fish a spot for about 2 1/2 hours, take off, make it about 300 yards missed and shut down. Pumped the fuel bulb back up, tried cranking on it for a few minutes, did not want to start. Finally just kept cranking on it til it started. Revved it up and down. Ran fine the rest of the day. The worst part was when it died i was running wide open and the sudden stop just saturated the back of the boat. does what i have just explained tell you anything more about the nature of my problem?

  2. Member
    Join Date
    Apr 2007
    Location
    Warm Springs, VA
    Posts
    1,713
    #2

    Re: Evinrude 150 Intruder Problem Part 2 (bperdue21)

    is this the part i need? on ebay item # 290060762482

  3. Member
    Join Date
    Apr 2005
    Location
    snellville
    Posts
    113
    #3

    Re: Evinrude 150 Intruder Problem Part 2 (bperdue21)

    I'd ask the eBayer the exact part # then cross ref back to your engine on the Bomb parts site


    that is a faststrike/Intruder PP

  4. Member
    Join Date
    Apr 2007
    Location
    Warm Springs, VA
    Posts
    1,713
    #4

    Re: Evinrude 150 Intruder Problem Part 2 (jglenn)

    i asked him, it was the replacement part. i think sierra.

  5. Member
    Join Date
    May 2004
    Location
    Nashville
    Posts
    11,165
    #5

    Re: Evinrude 150 Intruder Problem Part 2 (Z20moose)

    I would suggest when you replace a pack on these motors you also replace the EET (optical sensor) and vise versa.

  6. Member
    Join Date
    Apr 2005
    Location
    snellville
    Posts
    113
    #6

    Re: Evinrude 150 Intruder Problem Part 2 (bperdue21)

    personally I wouldn't get anything but an OCM/Bbomb power pack



  7. Member
    Join Date
    Apr 2007
    Location
    Warm Springs, VA
    Posts
    1,713
    #7

    Re: Evinrude 150 Intruder Problem Part 2 (jglenn)

    Got both parts today, hopefully putting the optical sensor on won't be a PITA.

Similar Threads

  1. Problem with '97 175 Evinrude Intruder
    By Boat5 in forum Evinrude/Johnson Motors
    Replies: 7
    Last Post: 06-06-2016, 08:05 PM
  2. 1992 Evinrude Intruder 175 help locating part
    By tsamp08 in forum Evinrude/Johnson Motors
    Replies: 1
    Last Post: 03-18-2012, 04:56 AM
  3. evinrude 150 intruder/ problem
    By egreen024 in forum Evinrude/Johnson Motors
    Replies: 11
    Last Post: 05-15-2008, 07:54 PM
  4. Problem with 91 Evinrude Intruder
    By maxe in forum Evinrude/Johnson Motors
    Replies: 7
    Last Post: 04-14-2005, 10:24 AM