I originally started off with the idea of selling these plates. At this time I have not been able to find any extruded railing that will work the same. Because of the fact that this plate started off as a factory Minn-kota mount, that alone eats up a 110.00 bucks right out of the gate. By the time it is said and done I bet I have 275.00 just in parts and labor. Machine work, anadize set-screw etc. I am working on it though.

The 1st plate I did I had to trash. I ran into some unforseen problems. I does work great though and I pulled 5+lbs off the factory minn-kota mount.

If anyone can help me find a source for a slide plate I will make them one for free. I would like to be able to sell these to the Bullet community. At this time the money is just not justifiable. Unless you are all about the custom