Results 1 to 3 of 3
  1. #1
    Member hirks's Avatar
    Join Date
    Jul 2008
    Location
    Courtice, ON
    Posts
    1,377

    Removing AN60 pins???

    Guys I pulled the back pin but the front one won't pop out,funny though I can spin it with my fingers but won't go out either side of tongue,is there a trick to this?Is it siezed on the rollers inside or what?

  2. Member
    Join Date
    Jun 2004
    Location
    Abilene
    Posts
    9,428
    #2

    Re: Removing AN60 pins??? (hirks)

    It has been in so long that it has got deep ware ridges in it. You will just have keep beating on it until you can get it out. There are no tricks to getting it out, the worn pin ridges have it holding in the slot. It will come out, just keep pounding and rotating the pin hope you don't mushroom the ends.





  3. Member hirks's Avatar
    Join Date
    Jul 2008
    Location
    Courtice, ON
    Posts
    1,377
    #3

    Re: Removing AN60 pins??? (rangerguy)

    Thx Rangerguy,I figured as much but on a long shot was hoping that removing the tongue latch/piston or something might allow it to pop out easier.

Similar Threads

  1. Laying out pins in Gel??
    By 87GT183 in forum Bassboat Restoration
    Replies: 11
    Last Post: 01-25-2012, 07:27 PM
  2. Cotter Pins
    By cull25 in forum Yamaha Motors
    Replies: 3
    Last Post: 03-24-2011, 07:30 AM
  3. 295 Strato Windshield Pins
    By setdhook in forum Stratos/Javelin Boats
    Replies: 5
    Last Post: 04-25-2008, 08:06 PM