Results 1 to 4 of 4
  1. #1
    Member
    Join Date
    Jun 2004
    Location
    Memphis
    Posts
    22

    still having problems

    1984 2.6 xp runs great for 15to 20 min on lake,then goes to crap looses power,doent do the same thing every time,sometime just misses and goes on sometime looses power and only run about 1000 rpmfor a bit then takes off like no prob, thought it was fuel (like sucking air) changed al lines and bulb, screens clean,sometime choke or pumping bulb help but usually dont,Think its luck when it helps.now i'm thinking electrical but dont know where to start,also 92-96 on compression,and plugs dont look to bad.

  2. Member
    Join Date
    May 2004
    Location
    Nashville
    Posts
    11,165
    #2

    Re: still having problems (rdc1656)

    After warming the motor to the point where it has the problem.....I would check the stator output, then check the timerbase output, if both of these are good, I would look at the packs.

  3. Member
    Join Date
    Jun 2004
    Location
    Memphis
    Posts
    22
    #3

    Re: still having problems (RUSTY63)

    can you tell me how and can i check it on a hose or do i need to do it at the lake.

  4. Member
    Join Date
    May 2004
    Location
    Nashville
    Posts
    11,165
    #4

    Re: still having problems (rdc1656)

    After its warm you can run the tests with the motor at cranking speed, not running.

Similar Threads

  1. More Problems!!!
    By Astro-T in forum Home Improvements
    Replies: 4
    Last Post: 03-31-2011, 07:31 PM
  2. problem problems problems lol
    By imthemedic in forum Evinrude/Johnson Motors
    Replies: 6
    Last Post: 09-01-2010, 06:51 AM
  3. ZX 200 problems
    By ZX200LA in forum Skeeter Boats
    Replies: 5
    Last Post: 07-10-2008, 12:59 PM
  4. E.M.M. problems
    By Hard Ard in forum Evinrude/Johnson Motors
    Replies: 15
    Last Post: 03-07-2007, 04:28 PM