Does anybody know if the 6th cylinder on a 1994 Evinrude 200 Vindicator runs lower than the rest? Mine is about 10#'s out.
Does anybody know if the 6th cylinder on a 1994 Evinrude 200 Vindicator runs lower than the rest? Mine is about 10#'s out.
The bottom 2 cyls will read lower most times!
They will read low, but when was the last time you decarbed? I would guess ring stick and piston scuff. when they are assembled at the plant the std bore is 3.685" and the piston and rings are installed in the block. Theoretically they should all show the same compression, when new. The pistons don't know what cylinder they are put in. As time goes on over the years the bottom 2 cylinders are closest to the exhaust ports in the mid section and all of the junk attaches itself to the bottom 2 pistons. That is why it is important to decarb at least once a year. I'll bet you have either ring stick or piston scuffing. But that is my .02. I'm only a hillbilly from SC,. CM
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by ChampioNman »</TD></TR><TR><TD CLASS="quote">But that is my .02. I'm only a hillbilly from SC,
Yeah, but your our hillbilly!!!
he aint from SC he from massachewsis ted kennedy state
[I]TEAM CORGI DOG[I]
1996 javelin 400T /1996 Johnson 200 Venom
I've got the yankme knocked out of me along time ago. Got a whole bunch of redneck in me!!
[I]TEAM CORGI DOG[I]
1996 javelin 400T /1996 Johnson 200 Venom
He's been hangin' wid me too long...... Bona Fide certified Redneck.......... snowbird!!!!
Reply With Quote
