Results 1 to 11 of 11

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member
    Join Date
    Nov 2004
    Location
    Bentonville, Arkansas
    Posts
    765

    Can I swap out my factory hydraulic bob's plate for a new Atlas plate?

    Are the holes the same? Are there any weight distribution issues? I like the Atlas design better than the Bob's. I have a 1998 Intimidator DE DC with a 225 ProXS. Might clean up my back compartment as the Atlas unit is self contained. Has anyone done this or checked on it? Lots of pros switching to the new atlas unit.

  2. Member
    Join Date
    May 2012
    Location
    Middle Georgia
    Posts
    9
    #2
    Can I get that old one from you I need one too

Similar Threads

  1. Gauge for Atlas Hydraulic Jack Plate
    By RangerCork in forum Ranger Boats
    Replies: 22
    Last Post: 02-12-2012, 12:16 PM
  2. Can the factory swap safety plate with new HP rating?
    By GamblerSam in forum Gambler Boats
    Replies: 11
    Last Post: 02-28-2011, 01:56 PM
  3. TH Marine Atlas Hydraulic Jack Plate 12"
    By Red_Bullet in forum Bullet Boats
    Replies: 6
    Last Post: 12-03-2009, 08:57 AM