My tilt/trim unit is getting power to it but I believe there is a seal that has gone bad. I can see a water and trim fluid mixture exuding from the unit where the tilt ram comes out. It has a very rough sound to it and has started working intermittenly. I opened the cap on the reservoir and a gray watery fluid came out. I then pumped new tilt and trim fluid in, raised and lowered the engine several times and repeated this several times. This gets the tilt/trim to work a little better but it is definately not fixing the problem. So, is there a seal replacement kit available for this? or is it a full replacement situation? The engine is a 99' Evinrude FICHT 225 model E225FPLEEO. Thanks for any advice and info any of you may provide.