If you have the drivers side optional tray as outlined in the picture below can you tell me who makes this and the name Triton uses to describe it? Can you also provide the overall dimensions from outside edge of flange to outside edge of flange in both the length and with dimensions and depth? Asking because I'm trying to customize my boat and need to know if it will fit where I'm trying to install it. Thanks in advance.
<u>1999 TR-21PD / 1999 Mercury 225 Optimax</u>
Mine is molded fiberglass it is about 10" long by 3" wide and 2.5" deep
In that spot on mine I actually have a little covered glove box. Pretty neat but it is not water tight.
Where did you buy your glove box? I would like to replace my middle seat with one.
I took my middle seat off. It is sooo much better getting to the back deck and don't have to worry about tearing up the seat stepping on it. I put a couple of globs of silicone on the holes from the inside.
Reply With Quote