Spent last Sat. re-building carbs on my 200 vindicator 93' in the unbearable heat we are having, finished them and I accomplished my goal of stopping all the fuel that was pouring from 3 of them. I have not performed lync-sync yet but I got impatient and started motor in driveway with the hose and it started and ran pretty good for not having back-pressure then I really got impatient and trailered it to the ramp tried it. My result is a motor that I can hardly get to start and when it does I can only keep it running with hotfoot at about 1800-2600 rpm once i reduce it down below 1500 it dies. My ? is will lync-sync fix my problem , I never touched the adjustable idle screws during re-build and I adjusted floats even with carb. bowl housing. Thanks Joe VE200 SLETF G03290181
Reply With Quote
Also you need to get a good service manual. I don't know if synk and link will fix your problem but it has to be done.
