This evening I'm planning on installing LEDs in the livewell. I'm using sealed strips and plan on placing them on rear side of the well at the top to eliminate glare.
Question is this. Does the livewell have acces at the top to run wires or is it glassed into the floor of the boat. Really don't want to drill holes in the livewell if I can pry back the well enough to pull the wiring through. Any input greatly appreciated. Take care.
Respectfully,
Captain Rab
V1CO 1:27 But God has chosen the foolish things of the
world to put to shame the wise; and God has
chosen the weak things of the world to put to
shame the things which are mighty
Mine is glassed in. Thinking about adding LEDS as well but using the over-flow to run the wires out. Drill a hole in the tube, run a metal clothes hanger up into the livewell, tape the wires to it, run them out the hole and seal with silicone. Seal the wires out of the way on the inside of the livewell along the top with aquarium grade / approved silicone.
Modified by 45cal4life at 2:13 PM 3/21/2012
Thanks for the reply. I did 2 12" green LEDs strips from autozone. Sealed front an rear with silicone. I drilled a hole at the top of the starboard side then soldered to the back of the courtesy light.
Came out fine with no issues.
Respectfully,
Captain Rab
V1CO 1:27 But God has chosen the foolish things of the
world to put to shame the wise; and God has
chosen the weak things of the world to put to
shame the things which are mighty
Reply With Quote