Results 1 to 9 of 9
  1. #1
    Member
    Join Date
    Jun 2004
    Posts
    1,155

    HT on heavier boats

    Are there any guys running phase kits on heavier rigs like Ranger, Skeeter, Champ, etc? Lots of info here on strokers and bullets, but no so much I'm finding on "lead sleds".

    What kind of performance gains did you guys see?




  2. Michigan Bass Club Moderator CGWright's Avatar
    Join Date
    Jul 2004
    Location
    Charlotte, MI
    Posts
    14,283
    #2

    Re: HT on heavier boats (cast1)

    Here's dentguy's information on his Skeeter. Pretty impressive!

    http://www.bbcboards.net...96764


    To report any post you disagree with press Alt + F4.

  3. Member
    Join Date
    Jun 2004
    Location
    Tulsa
    Posts
    239
    #3

    Re: HT on heavier boats (cast1)

    2004 champion 193dcx w/rear tank and stock 200 ox66 was 72mph gps with normal load. With phase 2 it ran 77 mph gps. With phase 3 and a little porting and hpdi gearcase w/1.75 gears it will run 84.6 with a normal load. Normal load is me and all my gear plus a 160 lbs. of ballast on passenger side with between 25 and 40 gal. of fuel. I have seen two mph more out of it but not with a respectable holeshot.
    John

  4. Member HaulinBass's Avatar
    Join Date
    Jun 2004
    Location
    Springfield
    Posts
    6,324
    #4

    Re: HT on heavier boats (onewht193)

    John, you animal. IM sent cast1.
    Hey John, you going to the Tablerock TOC?
    Larry Eby, 2004 ChampioN 188 Elite/2003 200 Hp Vmax OX66
    "Romans 10:9"

  5. Member
    Join Date
    Jun 2004
    Location
    Dickson Co
    Posts
    6,425
    #5

    Re: HT on heavier boats (HaulinBass)

    Our 300+'s have been run on Stratos, Champion, Legend, Pro Craft and all worked very well.

    I have S2 components outbout to HT now.......this one will be run on an Allison XB 21 Pro Sport and should see triple digits with ease.

    They consistently push my 200 Stratos' over 90 mph.



  6. Member
    Join Date
    Nov 2004
    Location
    Dodson Louisiana
    Posts
    694
    #6

    Re: HT on heavier boats (Todd Morgan)

    225efi on 225zx picked up 6mph with phase II. Thats with 4 batteries, 50gal fuel, two people loaded with tackle.

  7. Member
    Join Date
    Apr 2006
    Location
    OKC
    Posts
    1,123
    #7

    Re: HT on heavier boats (shortcast)

    What would a Phase 3 250 HPDI do to a Ranger Z21?

  8. Member
    Join Date
    Jan 2005
    Location
    Crystal Beach, Texas
    Posts
    1,059
    #8

    Re: HT on heavier boats (Pound4Pound)

    i would venture to say 3 to 4 mph.

  9. Member
    Join Date
    Apr 2006
    Location
    OKC
    Posts
    1,123
    #9

    Re: HT on heavier boats (JeffinParadise)

    So it could possibly become a 75-76 mph boat? I was hoping it would be more than that, but that's still not too bad for a Ranger.

Similar Threads

  1. Replies: 8
    Last Post: 02-10-2012, 10:35 AM
  2. Heavier weight oil in UFP Gold?
    By nealxb2003 in forum Trailers & Towing
    Replies: 2
    Last Post: 02-25-2011, 03:30 PM
  3. Lifting a 300XS to install heavier jackplate angles
    By YoungRE2 in forum Mercury - 3 Liter & 3 Liter High Performance
    Replies: 1
    Last Post: 01-09-2010, 11:31 AM
  4. Cobra Boats Look like Legend Boats
    By rangerjoe in forum Cobra Boats
    Replies: 4
    Last Post: 04-14-2008, 12:58 PM