Results 1 to 5 of 5
  1. #1
    Member
    Join Date
    Apr 2005
    Location
    Berea, KY
    Posts
    438

    04 175 HPDI Question??

    Ok here is the scenario, I am running down the lake and everything is normal, speed, RPMs, ect. I get to my next spot and throttle down and idle into where I am going to fish. When I go to put the throttle in nuetral I seems to be stuck. I finally got it into nuetral with quite a bit of force. For the rest of the day every time I put it into gear it was very hard to get it into gear and back into nuetral. Also it seemed like every time I ran to another spot I lost more and more RPM's. By the end of the day I could barely get on plane.

    I never heard any strange noises or anything like that. My first thought was a cable problem not allowing the throttle to open up fully. After talking with a few people some seem to think it might be a lower unit problem. Any ideas or suggestions to diagnose???

  2. NC Bass Club/Yamaha Motors Moderator BuzzB8's Avatar
    Join Date
    Jun 2004
    Location
    Asheboro, NC
    Posts
    7,090
    #2

    Re: 04 175 HPDI Question?? (mpb185vs)

    Check the cable under the cowling. Look where the cable is held down by a clip or bar, I bet that's your problem.

  3. Member
    Join Date
    Apr 2005
    Location
    Berea, KY
    Posts
    438
    #3

    Re: 04 175 HPDI Question?? (BuzzB8)

    Actually we did check under the cowl and 1 of the cables had jumped out of its slot and the plastic holder clip was undone. I just havent had a chance to run it again to see if that was the issue.

  4. Banned
    Join Date
    Feb 2010
    Location
    New Hampton, New Hampshire
    Posts
    1,104
    #4

    Re: 04 175 HPDI Question?? (mpb185vs)

    Have you checked your fluids in your lower unit?

  5. NC Bass Club/Yamaha Motors Moderator BuzzB8's Avatar
    Join Date
    Jun 2004
    Location
    Asheboro, NC
    Posts
    7,090
    #5

    Re: 04 175 HPDI Question?? (mpb185vs)

    <table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by mpb185vs &raquo;</td></tr><tr><td class="quote">Actually we did check under the cowl and 1 of the cables had jumped out of its slot and the plastic holder clip was undone. I just havent had a chance to run it again to see if that was the issue.</td></tr></table>

    Well, have you tried it yet?

Similar Threads

  1. 250 HPDI Question?
    By Grant2 in forum Yamaha Motors
    Replies: 3
    Last Post: 09-12-2011, 10:41 AM
  2. 03 HPDI Question
    By BttrBn in forum Yamaha Motors
    Replies: 5
    Last Post: 02-17-2011, 01:29 PM
  3. 200 HPDI Question?
    By buckrub13 in forum Yamaha Motors
    Replies: 5
    Last Post: 06-04-2008, 12:14 PM
  4. hpdi question ?
    By john tr 21 in forum Yamaha Motors
    Replies: 13
    Last Post: 12-16-2007, 10:38 PM
  5. 210 w/300 HPDI Set up Question ?
    By JeffinParadise in forum Blazer Boats
    Replies: 10
    Last Post: 11-21-2006, 03:33 PM