Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Feb 2006
    Location
    Monroe
    Posts
    12

    What can you all tel me about a 1973 Johnson 65HP model # 65ESLR73

    I looked the numbers up to find out what year it was. I'm assuming that the L stands for long shaft? The motor was suppose to have been rebuilt about 3 years ago and I have ridden on the boat two summers ago and it ran pretty good but it has been in storage for the last two years. I plan to rebuild the carbs, replace the impeller, plugs and what ever else you all think need replacing. Is there anything I might need to know about this engine? Any advice for a me for an engine that has sit for two years? Also, do you think this engine will make a 14' fiberglass bassboat move pretty well? I would appreciate any feedback.

    Thanks

    Brent

  2. Member
    Join Date
    May 2004
    Location
    Nashville
    Posts
    11,165
    #2

    Re: What can you all tel me about a 1973 Johnson 65HP model # 65ESLR73 (Bman72)

    I cant get any info on motors older than 1996 but I can tell you that the information you posted is correct.

    Sounds like you are covering the things that need to be covered on a motor that has set for two years.

  3. Member DoferGofer's Avatar
    Join Date
    Jun 2004
    Location
    Edgewood Maryland
    Posts
    1,807
    #3

    Re: What can you all tel me about a 1973 Johnson 65HP model # 65ESLR73 (RUSTY63)

    The three cylinder Johnson 60, 65, 70HP were very good engines and were very spunky little engines. You will be happy with its performance. Been there done that.

    If you can't run with the big dogs, just stay on the porch.

    Model E150DPLIIB, Serial 05311818, Mfg Date 02/2011

    SST... 14 1/2" x 19" 45.0 mph.@4950
    Rebel 15 1/2" x 17" 45.1 mph.@5250
    Rebel 15 1/2" x 16" 44.6 mph.@5300 (Re-pitched/Balanced/Blue Printed by Mark's Props)
    Rebel 15 3/4" x 15" 44.2 mph.@5700-5750

Similar Threads

  1. 1973 Johnson 65hp must run with choke
    By lawnwarrior in forum Evinrude/Johnson Motors
    Replies: 3
    Last Post: 03-26-2010, 11:22 AM
  2. Replies: 0
    Last Post: 05-18-2009, 12:38 PM
  3. 1973 65hp evinrude rods
    By jcb9901 in forum Evinrude/Johnson Motors
    Replies: 0
    Last Post: 07-22-2007, 01:41 PM
  4. 1973 65hp parts interchangeableity
    By jcb9901 in forum Evinrude/Johnson Motors
    Replies: 6
    Last Post: 07-14-2007, 03:18 AM
  5. 1973 Johnson 65hp, water in cylinders
    By strongcones in forum Evinrude/Johnson Motors
    Replies: 4
    Last Post: 04-29-2007, 08:06 AM