Someone posted instructions on doing this with pictures. Could someone direct me to this post or give me the info.
Someone posted instructions on doing this with pictures. Could someone direct me to this post or give me the info.
Lower your motor and look under the front of the engine housing. You will see a black plastic clamp under there and a Phillips screw on it. Loosen the screw until you can turn the clamp. Now turn the key on so the trim gage will function and move clamp to desired position and tighten screw but no too tight.
You will have to play with it a bit as the Gage will move when the clamp is tightened.
Mike
In Memory of Michael
Fantastic Father and Loving Son
A true man at 23 years old
"What was once a great country has been mortgaged and bankrupted by the egos and ethics of career politicians."
The directions are in the post above this one. Here's a picture.
![]()