Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Dec 2004
    Location
    Brighton
    Posts
    138

    Motor height setup for my boat

    I have a 2004 Ranger 520 w/225 Evinrude H.O (Non-Etec) w/a 6inch manual jackplate. The motor had a Raker on it that I sold this fall and then picked up a 25" and a 27" renegade because I fish big/rough waters (Lake Erie/St. Clair/Michigan) and I need the 4 blades. I haven't ran these props yet. I don't know my propshaft height related to the pad because it's in storage. What height should my motor be at for best performace with these 4 blades? Also which prop do you think will work better? I've also read that the H.O Evinrudes shouldn't go over 5800 rpms but the book says up to 6000. Just curious about that also.

    Thanks!!

  2. Member
    Join Date
    Dec 2004
    Location
    Brighton
    Posts
    138
    #2

    Re: Motor height setup for my boat (toadseeker)

    I read somewhere that 6000 rpms was o.k as the max, but I've also read that 5800 rpms is the max you want to go? Anybody else know?

  3. Sprint Boats Moderator Bassmeister's Avatar
    Join Date
    May 2004
    Location
    Calhoun, Ga.
    Posts
    47,086
    #3

    Re: Motor height setup for my boat (toadseeker)

    My 03 is turning the 27 Gade @5700 SWEEEEETTTT!!!! I'm running 2" below pad on my Sprint, I don't know the best on the Ranger you might try the setup boards as far as engine height goes! I wouldn't go over 5900.JMHO

Similar Threads

  1. 1999 193 setup for motor height?
    By FatBack in forum Champion Boats
    Replies: 1
    Last Post: 02-15-2012, 06:27 PM
  2. motor height on SL190, how do I lift motor ?
    By DrinkingEmu in forum Skeeter Boats
    Replies: 6
    Last Post: 05-12-2010, 03:32 AM
  3. Motor Height Setup Question
    By shootincyclone in forum Champion Boats
    Replies: 7
    Last Post: 04-08-2009, 12:54 PM
  4. 1988 CAJUN MOTOR SETUP HEIGHT
    By CAJUNFEVER in forum Cajun Boats
    Replies: 0
    Last Post: 02-16-2009, 12:22 PM
  5. Motor height or prop setup for my 520
    By toadseeker in forum Evinrude/Johnson Motors
    Replies: 2
    Last Post: 04-01-2006, 12:46 PM