Power Pole owners............

How did you run the hydraulic lines into the bilge from the power pole?? I hate to drill holes in the hull if I don't have to.

I am considering running them thru the black plastic piece at the rear where the rub rail meets between the jack plate???

Thanks, John.

I ran mine thru the big black plastic tube that all of your wiring runs thru. I took a razor knive and cut a small square right at the engine cowling by where the split is on the tubing. I ran both tubings thru there into the bilge. I then put two black tie straps around the big tube, one in front of where the lines go in and one behind where the lines go in. Works great.