07 591 Nitro Loose Throttle Control
My entire shifting/throttle lever feels a little loose, wobbles left to right, not much be enough to concern me. Plus thereÂs some small crews on the back side of the throttle handle that are very loose, small alum piece right at the bottom of the red neutral lever. When I pull up on the red neutral lever the aluminum piece slides out cuz the screws are backed out quite away and sometimes jams up my shifter. There in a difficult place to retighten and I can see they have a small torx head. I pried out the plastic cover thatÂs behind the lever and see some bolts but canÂt get the cover off with the handle in place. Can someone tell me how to get this lever off so I can tighten everything back up. Thanks
[img][http://i130.photobucket.com/albums/p...o/DSC00272.jpg/img]
[img]http://i130.photobucket.com/albums/p...o/DSC00274.jpg[/img]
[img]http://i130.photobucket.com/albums/p...o/DSC00271.jpg[/img]
[img]http://i130.photobucket.com/albums/p...o/DSC00270.jpg[/img]
Modified by Scully at 3:43 PM 3/27/2012
Re: 07 591 Nitro Loose Throttle Control (Scully)
A good starting point would be to provide a PICTURE of your control/handle.
Dozens of possible control boxes. http://www.bassboatcentral.com/smileys/wink.gif
Re: 07 591 Nitro Loose Throttle Control (EuropeanAM)
Ok guys pictures added. As you can see the alum piece at the bottom of the red lever will pop out of place because the crews are loose. I took one picture with it in place but i have the push it back in now and then.
Re: 07 591 Nitro Loose Throttle Control (Scully)
-Place control handle in the FORWARD position
-CAREFULLY pry out the "throttle only" Button (in center of control handle) with a small, flatblade screwdriver. Don't panic if it breaks- about 1 in 3 do (and replacements are available).
-RETURN CONTROL HANDLE TO NEUTRAL POSITION (IMPORTANT)
-Remove the center bolt that holds the control handle on.
-CAREFULLY slide the control handle off, being careful not to knife or cut the trim wires, or lose the plastic ring that buffers the handle from the faceplate.
-Address any loose hardware.
-Reinstall handle on shaft at NEUTRAL position.
-Install center bolt with BLUE LIQUID LOCTITE
-Snap throttle only button back in place.
Re: 07 591 Nitro Loose Throttle Control (EuropeanAM)
Thanks so much for your advise i'll give it a shot in a few days and let you know how it went.................. http://www.bassboatcentral.com/smileys/praying.gif