Search:

The Fury likes a little lighter boat and will turn about 200 less RPM than the same pitch tempest will. Fury has a better hole, tempest caries heavy load better, on lighter boats the Fury is a little...

Check for blown fuse on the motor, starboard side near PCM

lower cowls removed, first pry up on the grommet with a dull flat blade screwdriver, it is split grommet and is actually easy to remove, after running the wires lube the grommet and reinstall from...

6 gauge is fine, 4 gauge has no bearing on the circuit size as for function of the system or protection

replace the gate valve

In your case I would run 6 gauge from battery to fuse/buss box, 100 ah hour is to small for your needs, Get a 170 lithium to do double duty, cranking and house use, or 2 100ah on parralell...

not likely, it will be obvious if the Teflon seal is bad, check the brown 0-rings for burnt edges from combustion gases or better yet replace them and lube them with 2-4-C

.
Sure can, torque is critical on aluminum castings.
Most not using torque wrench will almost always overtighten Fastners which will induce a lot of stress in surounding areas resulting in...

At a single point, yes it would be of concern, Rule of thumb a maximum of 10% drop in the entire circuit which includes the ground side as well, everything from battery neg thru the loads and back to...

Impossible! In a series circuit current flow at any location is exactly the same regardless of any resistors at any location. Total resistance in that circuit will determine the current flow at a...

^^^^^^^ plus 100, Blues seas is a Buss breaker as well

The blacks must be kept connected together same for two purples, suspect they are not, also you may have tripped circuit breaker doing this work

25 fury 3 start at 3.5 in, no plugs, should run about 70-72 mph at 5750
Tempest prop should only have one medium hole plug with correct p to p 3 to 3.25 ht

Need to get air fuel pressure on the water under load while it is acting up, also need the low pressure reading from the Shrader valve on the vst

in lbs not ft lbs

Computer show a little over 900 hrs, very suspicious of a mixed bag of parts on this one

Here is a source for the proper adaptor hose
Star Products 71319 Small Schrader Hose Assembly with Quick Coupler Plug | JB Tools

:embarassed: Well I missed this one, throttle lever was very loose on the shaft, tps would be almost 50% before throttle blade moved, can't believe I missed that one when I replaced the roller,...

sleeve cracked or the block bore that contains it. Would like to see a pic of that crack, sleeves just do not crack normally. If the block cracked around the sleeve, not repairable, needs to be...

Would not run at all with those readings
should be 94 air 109 fuel........14.2 psi spread fuel must exceed air in order for fuel to flow

549558
Copper strap doubles as a mount and a connector to the battery teminal of the breaker>

European Marine, however I refuse to install Sea Clear systems. absolute junk, nothing is right about their design.
If someone is qualified to install that system, they should be able to design a...

water intrusion

Closer to 65.00 for a quality breaker, dont blow your money on cheap breaker, if your lucky they just go to open ckt, unlucky they burn your boat and it suroundings to the ground!

No