I have a 91 stratos any suggestions on getting the steering wheel off I don't beleive it's ever been off before looking to replace it........will this boat have 3/4" shaft?
Thanks
I have a 91 stratos any suggestions on getting the steering wheel off I don't beleive it's ever been off before looking to replace it........will this boat have 3/4" shaft?
Thanks
Lowe Stinger 175
I used a 3 jaw puller on my 99 blazer..
Blazin\'
<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by cpdieselhouse »</td></tr><tr><td class="quote">I used a 3 jaw puller on my 99 blazer..</td></tr></table>
+1 yOU TRY A PULLER?
BILLY. 1995 202DCX ELITE TEAM FATBOY
& 2000 tracker PT185
2015 Fish count
Days on the Water =5.
Big fish 1-5.5
Big fish 2-5.00000
Big fish 3-4.0
Big fish 4-3.0smallmouth
Big fish 5-@2.50
yeah it wouldn't move it I'm gonna replace the wheel so if damages a little thats ok but man it's stuck!!!!!!!!!
Lowe Stinger 175
Try some PB Blaster and let it soak. Then try puller again.
I too couldn't get my wheel off of my Gambler....tried a puller and no avail...I gave up.
_______________________________________
1997 Gambler Outlaw
Powered by Mercury
HDS 5 & HDS 7
Glowin' Thanks to Bluewater LEDs
Get some Kroil from Kano Labs. Spray it and let it soak for a little while should break it loose. Also get the shaft cold it will shrink and help in removing it. Hope this helps.
2018 Skeeter ZX225
2018 SHO 225
2020 Starcraft SLS3 HMX
2020 Yamaha F250
Did you try the pull on it while someone taps the shaft trick? Back almost all the way off the 3/4" nut. Put pressure by pulling on the top of the wheel and pull back with your knees. Have someone tap the nut with a hammer a few times. This have worked for me several times, only once did I have to get a puller. I believe there is some youtube vids on this.
1999 Champion 203
2000 Yamaha OX66 225
Mine was so difficult that I drilled a half inch hole to get the wheel puller to get a good bite on the bottom of the wheel finally popped off! Hope that helps someone else. I tried every method I could find online before drilling. 1991 Stratos 201
Hit the middle with a hammer...
A lot of guys are not using the puller correctly. Once you have it bolted on, put some tension on the center nut, then hit it with a heavy hammer 2 - 3 times, then a little more tension, and then hit it again. You should start feeling it moving when you put some more tension on each time.
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents