2007 Series 2 250 HPDI, stalls?

[back_lash]

Going to make a short run back to the ramp and when it cranked it kind of sputtered then started right up. Running back started cutting out and then died. Cranked back up with the sputter. Did the same thing again, turned off the power and seemed to run fine back to the ramp and cranked right up at the ramp to put it on the trailer. Any thoughts, could low voltage cause this? No alarms. Thanks

[rid 05 198]

Plugs?

[back_lash]

I’ll check them but wouldn’t think so as it was my 4th day on the lake and it ran perfect up until then.

[tlefire]

If you have one, water/fuel separator.

[CJ1]

Doubt it is electrical. Go through the fuel system, looking for bad hoses, lift pumps, filters as stated. I would start with lines, primer ect first. Ever had ALL of the filters done? CJ

[back_lash]

Replaced the fuel water filter and emptied into a glass and it was clean fuel. I’ll see if that makes any difference.