Custom no-skid step strip/pad

[jbabin76]

Who (if anyone) makes custom no-slip adhesive strip to install on the bow area? I want to protect this area of my bow as it's usually where I step off the bank or dock to get in. Leaning more towards the non-skid tape product versus a seadek product. Open to ideas as well. I've seen some 6-12" wide strips of non stick which I may just order and custom trip... but looking for ideas.

[jdwo2212]

Best to order a piece and cut to size. Lots of options on looks and feel.

[acfire]

Not sure what size you need but i ended up going to Lowes and they had a stick on non skid step piece for less than 10 bucks and its been on my boat for 3 yrs years no problems, Most home improvement stores have them for steps just measure size you would like and check them out .

[Lightning 6]

https://www.stewartssurestep.com/shop/sure-step/

These guys are great. Email them & they can cut custom to size….or order stock size & cut to size.

[JohnnyO]

I agree,

https://www.stewartssurestep.com/

[erico]

I just did this with eva deck foam from Amazon, was $25. Someone with more patience could make it look better

[FES313]

I used these in the stern where everybody kept putting their feet. I put them down with 4200. I found bigger sheets of this that could be cut to shape, a little googlin should get you what you need.
https://www.amazon.com/Keeper-05680-...5710857&sr=8-8

ETA:
I went to close my link and found this at the bottom of the page, https://www.amazon.com/dp/B0B2KSHGW1...kZXRhaWwy&th=1

[catdude28]

I've seen some 6-12" wide strips of non stick which I may just order and custom trip... but looking for ideas.

On one of my boats I used 2 inch wide strips, cut and shaped to size, and it worked great. Total cost was less than 5 dollars. You can see it in the pic on the bow. It was still on there after four years when I sold the boat.

IMG_0848.jpeg

[RazorCat]

Buy a 24”x24” (or larger) GatorSkinz step pad sheet and cut to size. I split a a 24”x48” pebble textured piece with a neighbor who needed to replace the original pads on a 2010 Skeeter. Perfect match.

[illinifish]

Buy a 24”x24” (or larger) GatorSkinz step pad sheet and cut to size. I split a a 24”x48” pebble textured piece with a neighbor who needed to replace the original pads on a 2010 Skeeter. Perfect match.

I used this product on the bow of my boat. I made a template out of poster board. It has held up extremely well for the 2 years I have had it on. I did replace mine when I updated trolling motors. I put the pad under the trolling motor mount.

[Unravels]

I used this for same thing on my basscat. You cut it to fit.

https://www.gator-guards.com/products/gatorskinz